The 3Dponics Mini is an easy and quick way to get started with DIY hydroponics gardens. All you need is a couple empty bottles and the 3D-printed bottle connector. No pump and no electricity required.

3Dponics Mini: Basic Parts

The only 3D-printed parts you need to build the 3Dponics Mini is the bottle connector. We’ve made two versions, listed below, to get you started.

Bottle Connector – Small

Allows you to attach two bottles together so that one acts as a reservoir, collecting run-off nutrient solution that can be reused. Compatible with the 3Dponics Drip System or with the 3Dponics Mini.

Download:

Download on ThingiverseDownload on SketchfabDownload on CGTraderBuy on MakexyzDownload on PinshapeDownload on GrabCADOrder on SculpteoDownload on GitHubDownload on YoumagineDownload on MyMiniFactoryDownload on 123DappDownload on Shapeways

Bottle Connector – Large

Larger version of the bottle connector allows for more room between bottles. Attach two bottles together so that one acts as a reservoir, collecting run-off nutrient solution that can be reused. Compatible with the 3Dponics Drip System or with the 3Dponics Mini.

Download:

Download on ThingiverseDownload on SketchfabDownload on CGTraderBuy on MakexyzDownload on PinshapeDownload on GrabCADOrder on SculpteoDownload on GitHubDownload on YoumagineDownload on MyMiniFactoryDownload on 123DappDownload on Shapeways

3Dponics Mini: Upgrades

Check out our ever-expanding list of upgrades and accessories for the 3Dponics Mini!

Bottle Sleeve

Slips over the neck of the plastic bottle and protects the plant’s roots from exposure to sunlight. Can also be used to enhance the appearance of your 3Dponics system to better fit your home decor. Compatible with the 3Dponics Drip System or 3Dponics Mini.

Download:

Download on ThingiverseDownload on SketchfabDownload on CGTraderBuy on MakexyzDownload on PinshapeDownload on GrabCADOrder on SculpteoDownload on GitHubDownload on YoumagineDownload on MyMiniFactoryDownload on 123DappDownload on Shapeways

Drain Cap

Acts like a plug or stopper, preventing the grow media from clogging and/or falling out of the bottom of the bottle while allowing water to pass through the holes.

Download:

Download on ThingiverseDownload on SketchfabDownload on CGTraderBuy on MakexyzDownload on PinshapeDownload on GrabCADOrder on SculpteoDownload on GitHubDownload on YoumagineDownload on MyMiniFactoryDownload on 123DappDownload on Shapeways